banner



How To Change Climate Control Lights On 98 4 Runner

  1. ramonortiz55

    ramonortiz55 [OP] New Member

    Joined:
    May 3, 2015
    Member:
    #590
    Letters:
    ane,665
    Gender:
    Male
    First Proper noun:
    Ramon
    Vehicle:
    2001 4runner limited argent millenium
    The illumination bulbs were out on my AC controls, ECT, rear window button, rear defroster, and ability betoken.

    This is a write up on the step past pace process I took to supersede the bulbs.

    My inquiry was done here: ***************************************************************************

    After reading thru those threads, I determined I needed the following office numbers. These are for a 2001 4runner, the bulbs for other 4runner generations might be different.

    2001 4runner limited climate control light bulbs:

    Part Number #81850-35050 - 2 Total
    Function Number #81850-35040 - ii Total

    Risk control light bulb:

    Part Number #84999-10860 - 1 Full

    ECT and Defroster light bulb:

    Role Number #90010-01041 - ane Total

    Rear window roll down:

    Part Number #90010-01042 - 1 Full

    Cigarette lighter:

    Part Number #84999-10250 - 1 Total

    ***************************************************************************

    Ordered all my bulbs from Camelback Toyota:

    [​IMG]

    Removing the center console cup holder, this is done by tugging it off:

    [​IMG]

    [​IMG]

    And so removing the shifter environment:

    [​IMG]

    Next, the radio surround is removed, gently pry it abroad from the dash:

    [​IMG]

    Pull it out slowly to reveal the plugs by the ac vents:

    [​IMG]

    Unplug the power indicate plugs:

    [​IMG]

    [​IMG]

    Once the ability point plug connector has been removed, locate the bulb - information technology is the gray end of the ability signal:

    [​IMG]

    Twist to remove:

    [​IMG]

    Side by side, I removed the hazard switch:

    [​IMG]

    This is done by releasing the side tabs:

    [​IMG]

    Adjacent, I removed this portion:

    [​IMG]

    This is done by releasing tabs at the ends AND at the meridian middle:

    [​IMG]

    [​IMG]

    Adjacent I removed the AC controls faceplate, tabs are on peak. This is very flimsy, so careful:

    [​IMG]

    [​IMG]

    I then removed the screws that hold in the AC control unit, disconnected the rear plugs and pulled information technology out:

    [​IMG]

    At this moment, I went ahead and installed the ability point seedling:

    [​IMG]

    Time for some surgery. Chance switch:

    [​IMG]

    Twist and pull out the bulb, replace with new 1:

    [​IMG]

    Now the strip, this has 2 bulbs. One for defroster and ECT, another seedling for the rear window switch:

    [​IMG]

    A needle olfactory organ pliers will allow the removal of one of the bulbs.

    [​IMG]

    To remove the other, the backing must be removed, a pocket-size apartment head screwdriver helps here. I then removed the other bulb and replaced information technology.

    [​IMG]

    Next step of the surgery was to open the front of the Air-conditioning control unit of measurement. I removed two screws. FOUR tabs need to be released on the tiptop and bottom. Forks or toothpicks assist keeping tabs open while I worked on other tabs.

    [​IMG]

    [​IMG]

    [​IMG]

    Advisedly opened the AC control unit..

    [​IMG]

    [​IMG]

    Bulbs removed and replaced:

    [​IMG]

    [​IMG]

    I and then assembled the Ac command unit together.

    Reinstalled everything dorsum together.

    Finally have all my illumination working properly!

  2. 2chains

    2chains New Fellow member

    Joined:
    Jul 23, 2017
    Member:
    #4436
    Messages:
    vi
    Just looking to do this. Cheers for posting the pics!
  3. ramonortiz55

    ramonortiz55 [OP] New Member

    Joined:
    May 3, 2015
    Member:
    #590
    Messages:
    i,665
    Gender:
    Male
    Commencement Name:
    Ramon
    Vehicle:
    2001 4runner limited silver millenium
    let u.s. know if you take any questions!
  4. I'm looking to this on my 2002 4runner soon. Is there a color option on the bulbs?
  5. ramonortiz55

    ramonortiz55 [OP] New Member

    Joined:
    May 3, 2015
    Member:
    #590
    Messages:
    ane,665
    Gender:
    Male person
    Start Name:
    Ramon
    Vehicle:
    2001 4runner express silver millenium
    If its stock OEM light bulbs.. NO.

    If you upgrade to LEDs (aftermarket), yes.

  6. AntonioCm1983

    AntonioCm1983 New Fellow member

    Joined:
    Dec 7, 2018
    Member:
    #7959
    Messages:
    iv
    Gender:
    Male person
    Starting time Name:
    Antonio
    Vehicle:
    2000 4runner
    Headlights taillights led conversions cold air intake engine mods bigger pistons cams lift kits big tires tones more than leds inside and out
    What an Amazing Walkthrough very much appreciated climate command bulbs all bad on mine been driving me nuts

Products Discussed in

To Top

How To Change Climate Control Lights On 98 4 Runner,

Source: https://www.4runners.com/threads/2001-4runner-replacing-ac-controls-and-ect-illumination-bulbs-pictures.3097/

Posted by: foorlusell.blogspot.com

0 Response to "How To Change Climate Control Lights On 98 4 Runner"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel